Family-owned masonry & hardscape contractor serving greater Boston for over 30 years.245 Salem St, Woburn, MA · Mon–Fri 7am–5pm
Gerrior Masonry & Landscape
Tall natural stone chimney with a metal cap on a white clapboard house
Chimneys

Brick Chimney Repair Options: Which Fix Fits the Damage

Brick chimney repair options explained: repointing, brick replacement, crown repair or a partial rebuild, plus stone and concrete block chimneys.

By Gerrior Masonry & Landscape, Woburn, MAUpdated October 16, 20264 min read
On this page
  1. Match the symptom to the repair
  2. The four masonry repairs
  3. Brick, stone and block chimneys
  4. Masonry vs prefab metal chimneys
  5. Is brick chimney repair a DIY job?
  6. When to call a mason
  7. Common questions

Brick chimney repair comes in four main options, and the right one depends on what is failing: repointing when the mortar joints are the problem, brick replacement when individual bricks are cracked or spalled, crown repair or replacement when the top of the chimney is letting water in, and a partial rebuild when damage above the roofline is widespread. Most brick chimney problems trace back to water, so the fix that lasts is the one that also stops the water getting in.

Gerrior Masonry, a family-owned mason in Woburn, MA, sets out how to match the symptom to the repair, how brick, stone and block chimneys differ, and which parts of a chimney belong to other trades.

Match the symptom to the repair

  • Recessed, cracked or crumbling joints: repointing. Done by a mason. See chimney mortar repair.
  • A few cracked, flaking or loose bricks: brick replacement and repointing. Done by a mason.
  • Cracked or crumbling top surface: crown repair or a new crown. Done by a mason.
  • Widespread spalling, loose top, leaning chimney: partial or full rebuild. Done by a mason. See chimney rebuild.
  • White staining (efflorescence): find the water source first; cleaning alone will not stop it. See efflorescence vs spalling.
  • Leak at the roofline: often flashing, which is roofer work. See chimney flashing or crown.
  • Missing or rusted cap, damaged flue liner: a chimney sweep or chimney specialist.

The four masonry repairs

Repointing

Failed mortar is cut out to a set depth and replaced with new mortar matched to the brick. On older chimneys the original mortar was often a soft lime mortar, and that was the right choice for the soft brick of the time; the new mortar should stay softer than the brick (National Park Service Preservation Brief 2).

Brick replacement

Damaged bricks are cut out and new or reclaimed bricks are set in their place. The challenge is matching size, color and hardness. Our chimney brick guide covers matching.

Crown repair or replacement

Hairline cracks in a sound crown can be sealed with a crown repair product. A crown that is badly cracked, flat or just a thin mortar wash should be replaced with a properly sloped crown with a drip edge (IRC section R1003.9.1).

Partial rebuild

When the brick above the roof is failing across the board, taking that section down and rebuilding it with a new crown usually lasts longer than patching.

A red brick chimney with weathered mortar joints and a worn concrete crown, seen from the roof
A red brick chimney with weathered mortar joints and a worn concrete crown, seen from the roof.

Brick, stone and block chimneys

  • Brick: the most common. Repairs are repointing, brick replacement and crown work.
  • Natural stone: very durable, but joints are wider and irregular. Repairs involve resetting loose stones and repointing with a mortar suited to the stone.
  • Concrete block: common on mid-century homes and on the hidden backup of many brick chimneys.

Block chimney repair

Block chimneys often have a cement parge coat over the block. Common problems are spalling block faces, cracked or delaminating parging, and open joints. Repairs usually mean removing loose parging, repairing or replacing damaged block, and re-parging. A breathable masonry water repellent can reduce how much water the block absorbs; a film-forming sealer that traps moisture can make spalling worse.

Masonry vs prefab metal chimneys

Many newer homes have a factory-built fireplace with a metal chimney, sometimes boxed in with siding or covered in brick or stone veneer. If yours is a metal flue inside a framed chase, the chimney itself is repaired by a chimney or fireplace specialist, not a mason. A mason can help with masonry veneer around it.

Is brick chimney repair a DIY job?

Small repointing at ground level is manageable for a careful homeowner. Most chimney repair happens on a roof, often two or three stories up, with heavy material. Working safely at height is reason enough to hire it out.

When to call a mason

Call when you see spalling brick, open joints, a cracked crown or any lean. Have it checked before winter: in Massachusetts, water in the masonry freezes and makes small damage bigger each year. Gerrior repairs and rebuilds brick chimneys through our chimney repair service; see real jobs in our chimney project photos. For cap, liner and flue issues, a CSIA-certified sweep is the right call.

Common questions

What is the most common brick chimney problem?

Water getting in through failed joints or a cracked crown, which then causes spalling as it freezes.

Can a few bricks on a chimney be replaced?

Yes. Damaged bricks are cut out and replaced with matched brick, then the joints are repointed.

Should I seal my brick chimney?

Only with a breathable masonry water repellent, and only after joints and the crown are repaired. Sealing over cracks traps water.

How do I know if my chimney needs a rebuild?

Leaning, loose bricks at the top, and widespread spalling are the main signs. See our chimney rebuild guide.

Gerrior Masonry has repaired masonry around Woburn for over 30 years, is fully insured and guarantees its work. For cost questions, see what drives chimney repair cost. Call (781) 933-4157 or request a free estimate.

Gerrior Masonry & Landscape
Written by Gerrior Masonry & Landscape

A family-owned masonry and hardscape company at 245 Salem St, Woburn, MA, in business for over 30 years. See our chimney repair work.

Keep reading

Have a project in mind? Start with a free estimate.

Office
245 Salem St, Woburn, MA
Hours
Mon–Fri 7am–5pm
Family-owned
Over 30 years
Coverage
Fully insured