Dry wells:what they are and when you need one
If your yard stays soggy, water pools by the foundation, or the basement gets damp after rain, a dry well is often part of the fix. Here's how dry wells work, how they're sized, and when something else is the better answer.
A place for water to go
A dry well is a buried pit filled with stone, or a perforated chamber set in stone, that collects runoff from downspouts, a sump pump or a soggy low spot and lets it soak slowly into the ground instead of pooling on the surface or against your foundation.
What is a dry well?
A dry well is an underground spot built to take in water and release it slowly into the surrounding soil. There are two common types:
- Stone-filled pit: a hole lined with filter fabric and filled with clean crushed stone. Water fills the gaps between the stones and soaks out through the sides and bottom.
- Chamber dry well: a plastic or precast concrete tank with holes in its sides, set in a bed of crushed stone. The open tank holds more water for its size than a pit of stone does. When people search for a "500 gallon" or "1,000 gallon" plastic dry well, this is the type they mean.
Either way, water reaches the well through a solid pipe from a downspout, a sump pump discharge, a catch basin or a French drain, and the well spreads it into the ground instead of across your yard or against your foundation.
Signs you might need one
- Downspouts that dump water which runs straight back toward the house.
- A low spot in the yard that stays a swamp for days after rain.
- A sump pump that keeps discharging water that just circles back.
- A wet strip along the side of the house, or water pooling at the bottom of the bulkhead stairs.
- A basement that gets damp during heavy or long rains.
If water is already coming through the foundation wall, a dry well alone won't fix the wall. That is a job for foundation and drainage repair, where the dry well is one piece of the plan.
How big should a dry well be?
There is no standard size. The right size comes from two things: how much water flows in, and how fast your soil can take it.
The water side is simple math. One inch of rain on 1,000 square feet of roof is roughly 600 gallons. A downspout that drains half of a 2,000 square foot roof can send about that much in a single one-inch storm, and a Massachusetts nor'easter can drop more than that. A well does not have to hold the whole storm at once, because water soaks out while it fills, but the slower your soil drains, the more storage you need.
The soil side is why we look at the site before sizing anything. Sandy, gravelly ground takes water quickly. Clay, compacted fill or ledge (solid bedrock close to the surface, common in this part of Massachusetts) takes it slowly or not at all. A test hole dug where the well would go shows how quickly the soil takes water. In slow soil the answer may be a larger well, two smaller wells, or a different approach altogether.
How deep should a dry well be?
Deep enough to take the water, but not so deep that it sits in groundwater. A few rules of thumb:
- The bottom of the well has to stay above the seasonal high water table. In spring, groundwater in many yards rises close to the surface, and a well sitting in it has nowhere to send water.
- The inlet pipe needs a steady downhill slope from the downspout to the well, which sets how deep the top of the well ends up.
- Pipes should be buried or sloped so they drain completely and don't hold water that can freeze in a New England winter.
- Ledge sets a hard limit. If the excavator hits rock, the design changes.
Where to put a dry well
Place it downhill from the house and well away from the foundation, often 10 feet or more, so the water you are moving doesn't soak back toward the basement. Keep it clear of a septic tank and leach field, a private water well, and property lines, and don't put it where water would flow onto a neighbor's yard. Roof water is the best fit. Runoff from a driveway carries oil and road salt, and it needs a different treatment.
What stone goes in a dry well?
Clean, washed, angular crushed stone, often in the 3/4 inch to 1-1/2 inch range. "Clean" matters most: stone mixed with sand or stone dust fills the empty spaces the water needs. Filter fabric around the stone keeps the surrounding soil from washing in. A leaf screen or basket at the downspout and an inspection port on top of the well help it last longer.
Dry well vs. French drain
They do different jobs, and they often work together. A French drain is a trench with perforated pipe in stone that collects water along a line, such as the side of a house or the bottom of a slope, and carries it somewhere. A dry well is a single spot that receives water and lets it soak into the ground. A common setup is a French drain along a wet side yard that empties into a dry well downhill from the house.
Dry well alternatives
A dry well is not always the right tool. Depending on the yard, these may work better or be needed alongside one:
- Regrading so the soil slopes away from the house. This is often the first fix.
- Downspout extensions or underground piping that carry roof water farther from the foundation.
- A swale, a shallow grassy channel that steers surface water around the house.
- A rain garden, a planted low spot that soaks up runoff.
- A catch basin piped to a point where water can safely leave the property, where the slope allows it.
Why a dry well stops draining
When a dry well stops draining, the cause is usually one of these:
- Silt and leaves. Without a screen or filter fabric, debris fills the stone or the chamber over time.
- The wrong soil. The well was built in clay or fill that can't take water fast enough.
- High groundwater. It works in summer but backs up every spring.
- Too small. More roof was tied in later, or the well was undersized from the start.
- A blocked or crushed pipe between the downspout and the well, or roots in the line.
Some can be cleaned out through an inspection port and fitted with a filter. Others need to be dug up, rebuilt bigger, or paired with a second well. A clogged pipe is sometimes the whole problem, so the line gets checked before the well is replaced.
Maintenance
Keep the gutters clean, keep downspout screens clear, and look into the inspection port after a big storm. If water is still standing in the well a couple of days later, it is draining slower than it should, and catching that early is easier than digging up a clogged well.
Dig Safe and permits in Massachusetts
Installing a dry well means digging, so it starts with Dig Safe. Massachusetts requires excavators to notify Dig Safe at least 72 hours before digging, not counting weekends and holidays, so buried utility lines are marked. Work close to a wetland or stream can also need approval from your town's Conservation Commission under the Massachusetts Wetlands Protection Act, and some towns have their own drainage rules. We check what applies before the job is scheduled.
What drives the cost of a dry well
Dry well prices you see online are often just for the tank. On a real job, the digging, stone, piping and restoration are a big part of the cost. What moves the number:
- Size and number of wells, which come from the roof area and the soil.
- Depth and soil. Clay, fill and especially ledge make digging slower and can change the design.
- Access. Whether a small excavator can get through the gate and across the yard, or the digging has to be done in a tighter space.
- Pipe run. How far the well is from the downspouts or sump, and how many lines tie in.
- Restoration. Putting back lawn, plantings, a walkway or patio pavers after the dig.
- Related work, such as regrading or a French drain feeding the well.
That is why we size and price a dry well after seeing the site.
A local example
In Reading, Larry P. had us back for a drainage job after earlier work he was happy with. His review notes the crew was careful in the yard and that "Joe was excellent with the little excavator," which is the kind of machine that makes drainage work possible in a finished backyard without tearing it apart. You can read his full review below, and see more of our work in Reading, MA.
Joe and his crew just finished up a drainage job for us. They were on time, great to work with (as usual) and the guys always friendly. They were very careful in the yard and Joe was excellent with the little excavator. They have done work for us in the past and we were very satisfied then and we feel just as pleased with this project.Larry P., Reading, MARead more reviews
Dry wells, answered
01Will a dry well fix my wet basement?
Often it is part of the fix, not the whole thing. If water is reaching the basement, we look at grading, gutters, drains and the foundation together. A dry well gives the collected water a place to go, but it works alongside those other pieces.
02What does a dry well cost?
It depends on the size and number of wells, the depth, your soil (clay and ledge slow things down), how easily equipment can reach the spot, the length of pipe, and what has to be restored afterward. We price it after seeing the site, and the visit is free.
03How big should my dry well be?
Big enough for the roof or yard area that drains into it, adjusted for how fast your soil drains. One inch of rain on 1,000 square feet of roof is roughly 600 gallons, so a large roof on slow soil needs much more storage than a single downspout on sand.
04Can I connect my sump pump to a dry well?
Often, yes, as long as the well is far enough from the house that the water doesn't cycle back to the foundation, and the discharge line is set up so it won't freeze in winter. The well also has to sit above the seasonal water table, or it will fill with groundwater when the pump is running most.
05How long does a dry well last?
A properly sized and installed dry well can work for many years. They can silt up over time, especially without a filter or screen or if undersized, which is why correct sizing, filter fabric and an inspection port matter.
06Do dry wells work in clay soil?
They can, but clay drains slowly, so the design has to account for it, usually with a larger well, more than one well, or a different drainage strategy. The actual soil should be checked before deciding.
07Do I need a permit for a dry well in Massachusetts?
Every job that involves digging needs a Dig Safe notice first. Beyond that it depends on your town and the site. Work near a wetland or stream can need Conservation Commission approval, and some towns have their own drainage rules. We check what applies before scheduling.
Let's solve the water problem. Start with a free estimate.
- Office
- 245 Salem St, Woburn, MA
- Hours
- Mon–Fri 7am–5pm
- Family-owned
- Over 30 years
- Coverage
- Fully insured